Composition and origin of PM2.5 in Mediterranean Countryside.

In this work PM2.5 was collected during winter and summer in a Sardinian village (Gonnostramatza, Italy) highly affected by biomass burning emissions. A multi-technique approach was adopted for the complete PM chemical characterization. The bulk characterization was performed by IC (Ion Chromatography), HPAEC (High-Performance Anion-Exchange Chromatography), TOT (Thermal Optical Transmittance) and ED-XRF (Energy-Dispersive X-Ray Fluorescence) while XPS (X-ray Photoelectron Spectroscopy) was used for the surface characterization. Using levoglucosan as specific tracer of biomass burning emissions, the assessment of the impact of this source was carried out and it represent the major PM source at the investigate site during winter. In winter the average levoglucosan concentration is 2096 ±â€¯324 ng/m3 while during summer its concentration is negligible (18 ±â€¯7 ng/m3). Levoglucosan content in PM2.5 during winter is on average 13.7%; it is estimated that 65% of PM2.5 is due to wood burning. XPS has been exploited in this work aiming at highlighting possible differences between surface and bulk composition of PM2.5. The surface of the particulate matter resulted enriched in carbon compared to the bulk. Among the components of XPS C1s signals recorded on the samples collected during winter, it was found that the signal at 286.5 eV, which is due to the presence of COH, reflects the bulk composition of levoglucosan.

Surface chemistry and surface reactivity of fibrous amphiboles that are not regulated as asbestos.

Three fibrous amphiboles that are not regulated as asbestos--two from Biancavilla (Sicily, Italy) and one from Libby (MT, USA)--were studied in order to establish relationships between surface chemistry and surface reactivity. The three fibrous samples, plus one prismatic fluoro-edenite from Biancavilla that was used for comparison, were investigated by X-ray photoelectron spectroscopy (XPS) in order to obtain their quantitative surface compositions and to determine the chemical environment of the Fe in each case. In particular, the Fe 2p(3/2) peak was fitted and, for the first for these materials, the binding energies of Fe(II) oxide, Fe(III) oxide and Fe(III) oxyhydroxide were identified. Bulk chemistries and Fe oxidation states were obtained from previous studies for the samples from Biancavilla, and were investigated in the present work by electron microprobe (EMP) and (57)Fe Mössbauer spectroscopy (MS) for the sample from Libby. Comparison between surface and bulk data revealed that the sample with the lowest bulk Fe oxidation state was the one most affected by surface oxidation, while the samples with bulk highly-oxidised Fe were showing very high signal of Fe (III) oxy-hydroxide probably due to weathering. The surface reactivities of the fibrous amphiboles were investigated by measuring the production of the [DMPO, HO]• radical adduct using electron paramagnetic resonance (EPR) spectroscopy. Notably, significant chemical reactivity was observed; it was found to be comparable with--or, for the Libby sample, even higher than--that of fibrous tremolite (one of the six asbestos minerals). A positive linear correlation was observed when the production of HO• radical was plotted versus the Fe(II) content on the fibre surface. Data on fibrous tremolite obtained from previous studies were added to substantiate the correlation. These results provide evidence that Fe(II) at the fibre surface controls the production of radicals at the fibre surface. The observed relationship provides further confirmation that Fe topochemistry is strictly related to--though not solely responsible for--the toxicity of asbestos and other fibrous amphiboles that are not regulated as asbestos.

An XPS analytical approach for elucidating the microbially mediated enargite oxidative dissolution.

In this work, the microbe-mediated oxidative dissolution of enargite surfaces (Cu(3)AsS(4)) was studied on powdered samples exposed to 9K nutrient solution (pH 2.3) inoculated by Acidithiobacillus ferrooxidans initially adapted to arsenopyrite. These conditions simulate the acid mine environment. The redox potential of the inoculated solutions increased up to +0.72 V vs normal hydrogen electrode (NHE), indicating the increase of the Fe(3+) to Fe(2+) ratio, and correspondingly the pH decreased to values as low as 1.9. In the sterile 9K control, the redox potential and pH remained constant at +0.52 V NHE and 2.34, respectively. Solution analyses showed that in inoculated medium Cu and As dissolved stoichiometrically with a dissolution rate of about three to five times higher compared to the sterile control. For the first time, X-ray photoelectron spectroscopy (XPS) was carried out on the bioleached enargite powder with the aim of clarifying the role of the microorganisms in the dissolution process. XPS results provide evidence of the formation of a thin oxidized layer on the mineral surface. Nitrogen was also detected on the bioleached surfaces and was attributed to the presence of an extracellular polymer substance layer supporting a mechanism of bacteria attachment via the formation of a biofilm a few nanometers thick, commonly known as nanobiofilm.